解决你困扰已久的台式机无线WiFi网卡断流、高PING、丢包的问题

发布于 2020-05-28  1.42k 次阅读


最近组装了一台台式机给自己用,因为家里没有布置网线接口,而路由器又在客厅,所以在淘宝买了个高通的无线网卡,但是买回来之后总是时不时网卡出现无网络连接的情况,特别烦人,也影响学习和工作。

后面和店家沟通,换了一块网卡,还是同样的问题,这下不好意思再和卖家换了,这张网卡花了65元,又没有运费险,换货已经多花了8元的邮费,如果再换也不划算了。

没办法,去网上找些土法子来用吧。(之所以是说土法子,是因为我并不知道这背后的原理,很玄乎)

方法一 重新启用WLAN AutoConfig服务

Win键 + R,弹出“运行”窗口,然后输入“services.msc"

打开后找到”WLAN AutoConfig",停止后再启用就好了。

方法二 禁用自动扫描WiFi网络

新建一个记事本文件,内容如下:

@echo off
title Fix for Wireless Ping Spikes (self.GlobalOffensive)
echo submitted by Clyq, bat by Ment-0
echo ------------------------------------------------------------------
echo Stop your Wireless Card from searching nearby networks and
echo updating your signal quality when you're not asking it to, 
echo which is what is causing the spikes.
echo ------------------------------------------------------------------
echo You will need to turn it back on if you disconnect or need to be 
echo able to find nearby networks again. 
echo Good Luck!
echo ------------------------------------------------------------------
pause
:MENU
cls
echo ------------------------------------------------------------------
echo -------------------Fix for Wireless Ping Spikes-------------------
echo ------------------------------------------------------------------
echo Option 1: Disable searching for networks and updating quality.
echo Option 2: Enable searching for networks and updating quality.
echo Option 3: Exit.
SET /P M=Type 1, 2 OR 3 then press ENTER:
IF %M%==1 GOTO DISABLE
IF %M%==2 GOTO ENABLE
IF %M%==3 GOTO END
:DISABLE
cls
netsh wlan show settings
echo.
echo The last line should be like: Auto configuration logic is 
echo enabled on interface "WiFi"
echo.
echo If so, type what is says after interface.
echo EXAMPLE if interface="WiFi" then you type: WiFi
SET /P input=Type here:
netsh wlan set autoconfig enabled=no interface="%INPUT%"
pause
GOTO MENU
:ENABLE
cls
netsh wlan show settings
echo.
echo The last line should be like: Auto configuration logic is 
echo disabled on interface "WiFi"
echo.
echo If so, type what is says after interface.
echo EXAMPLE if interface="WiFi" then you type: WiFi
SET /P input=Type here:
netsh wlan set autoconfig enabled=yes interface="%INPUT%"
pause
GOTO MENU
:END
exit

命名为“禁用WiFi自动扫描”,后缀名为“.bat”。

连接到网络之后,打开此批处理文件,按任意键继续,再按1回车,最后输出接口“WLAN”即可。

20200528202723.png

20200528202737.png

20200528202816.png

如果要连接其他无线网络,则要启用自动扫描,这时按2回车,最后再输出接口“WLAN”即可。

需要注意的是,关闭自动扫描后重启并不会开启自动扫描。

参考

USB无线网卡每隔固定时间就丢包或者高延时怎么破?

本文标题:《解决你困扰已久的台式机无线WiFi网卡断流、高PING、丢包的问题》

本文链接:https://wnag.com.cn/1342.html

特别声明:除特别标注,本站文章均为原创,本站文章原则上禁止转载,如确实要转载,请电联:wangyeuuu@qq.com,尊重他人劳动成果,谢过~


正因为有要好好实现的梦想,所以今天也要好好加油。